START-UP
 

PLEASE NOTE:

Consult factory for optional coated evaporator coils, required for acidic or abnormal

conditions.

If system is equipped with oil level sight glass the level should be 1/2 to 3/4 of the way up.

If oil level is low, add correct oil to compressor. DO NOT OVERFILL.

If necessary, temporarily by-pass fan delay control, to run fans until temperature is lowered.

Be sure expansion valve is properly set to provide correct amount of superheat.

Pour water in drain pan to check proper drainage.

Heavy moisture loads may be encountered when starting system for the first time. If coil

temperature is below freezing, this will cause a rapid build-up of frost, during initial pull

down. Manual defrosting may be required.

CONTACT//
KOLD PACK, INC.
5014 PAGE AVENUE
JACKSON, MICHIGAN 49201
1-800-824-2661

CUSTOM COOLERS , LLC.
5609 AZLE AVE.
FORT WORTH, TEXAS 76114
1-800-627-0488